中國(guó)有色金屬學(xué)報(bào)(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 33 No. 1 January 2023 |
（1. School of Materials Science and Engineering, Central South University, Changsha 410083, China;
2. State Key Laboratory of Power Metallurgy, Central South University, Changsha 410083, China;
3. Applied Materials Science, Department of Engineering Science, Uppsala University, Uppsala 75121, Sweden）
Abstract:Microstructure and mechanical properties of friction-stir-welded Al-5.50Mg-0.45Mn and Al-5.50Mg- 0.45Mn-0.25Sc-0.10Zr (wt.%) alloys were investigated by tensile tests and microscopy methods. The results show that the yield strength, ultimate tensile strength and elongation of the Al-Mg-Mn joint are (191±3) MPa, (315±1) MPa and (4.8±1.9)%, respectively. The corresponding values of the Al-Mg-Mn-Sc-Zr joint are (288±5) MPa, (391±2) MPa and (3.4±1.0)%. The Al-Mg-Mn-Sc-Zr joint has smaller grain size, lower average misorientation angle and higher low-angle grain boundary fraction than the Al-Mg-Mn joint. Both the two joints fracture at the weld nugget zone (WNZ), and Al3(Sc1-xZrx) nano-particles with a mean size of (9.92±2.69) nm still remain in this “weakest zone”. Theoretical calculation indicates that nano-particles can provide Orowan and grain boundary strengthening in WNZ, increasing the yield strength of the Al-Mg-Mn joint by 97 MPa.
Key words: aluminum alloy; strength; friction stir welding; nano-particle; microstructure
