(燕山大學 國家冷軋板帶裝備及工藝工程技術研究中心，秦皇島 066004)
摘 要: 為解決鈦/鋁復合軋制時變形不協調問題，對電磁感應加熱和軋制過程進行了實驗，實現了鈦、鋁兩金屬在溫差約600 ℃以上的條件下軋制復合，并通過有限元模擬研究了板坯溫度和壓下率對鈦/鋁復合板的變形協調性能和結合強度的影響。結果表明：當鈦板加熱溫度為850 ℃、壓下率在30%~48%范圍內時，隨著鈦板加熱溫度升高和壓下率的增加，鈦板和鋁板的變形協調性得到較大改善。當鈦板溫度為850 ℃、軋制壓下率為48%時，復合板結合強度達到77 MPa。
關鍵字: 鈦/鋁復合板；感應加熱；軋制復合；協調變形；結合強度
（National Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University, Qinhuangdao 066004, China）
Abstract:In order to solve the problem of uncoordinated deformation of Ti/Al in composite rolling, the experiments were implemented on the process of electromagnetic induction heating and rolling, titanium and aluminum were rolled and combined under the temperature difference above 600 ℃, and the effects of plate temperature and reduction rate on deformation compatibility and bonding strength of Ti/Al composite plate were studied with finite element simulation. The results show that, when the heating temperature of titanium plate is 750-850 ℃, the reduction rate is 30%-48%, the deformation coordination of titanium plate and aluminum plate greatly improves with the increase of heating temperature and reduction rate on titanium plate. When the temperature of titanium plate is 850 ℃, the rolling reduction is 48%, the bonding strength of the composite plate reaches 77 MPa.
Key words: Ti /Al composite plate; induction heating; rolling compound; coordinate deformation; bonding strength
