(中南大學 冶金與環境學院，長沙 410083)
摘 要: 針對鹽湖鹵水電解提鋰工藝的特性及其電解槽內流體流動的特征，分別研究電解槽進水口位置、流體流量、流體黏度對槽內流場的影響。通過水力學實驗與數值模擬對比，驗證所采用數學模型的適用性。結果表明：標準k-ε湍流模型能準確的反映槽內流體的流動狀況；對于黏度較大的鹽湖鹵水，為了強化傳質，進水口宜開在進水端中間位置，同時，在不破壞涂覆電極的前提下，應盡可能地增大流體流量。
關鍵字: 鹽湖鹵水；電解槽；流場；數值模擬；黏度；標準k-ε湍流模型
（School of Metallurgy and Environment, Central South University, Changsha 410083, Hunan, China）
Abstract:According to the characteristics of lithium electrolytic extraction and the fluid flow in the electrolyzer, the effects of the inlet position, fluid flow rate and fluid viscosity on the flow field in the electrolyzer were studied, respectively. Through the comparison of hydraulic experiments and numerical simulation, the applicability of the mathematical model was verified. The results show that the standard k-ε turbulence model can accurately describe the flow state of the fluid in the electrolyzer. Considering the larger viscosity of the salt lake brine, the inlet should be posited in the middle of the water inlet position, and the fluid flow should be increased as much as possible under the premise of without damaging the coated electrode to strengthen the mass transfer.
Key words: salt lake brine; electrolyzer; flow field; numerical simulation; viscosity; standard k-ε turbulence model
