(1. 湖南大學 材料科學與工程學院，長沙 410082；
2. 湖南大學 噴射沉積技術及應用湖南省重點實驗室，長沙 410082；
3. 中南大學 粉末冶金國家重點實驗室，長沙 410083)
摘 要: 采用Gleeble-3500熱模擬試驗機對Mg-5Zn-1Mn鎂合金進行大變形(變形量為80%)熱壓縮實驗，研究變形溫度為250~400 ℃、應變速率為1~40 s-1范圍內變形過程中合金的組織演變規律和流變行為。結果表明：該合金在上述工藝條件下進行熱壓縮變形時均發生了明顯的動態再結晶，且高應變速率下獲得的再結晶組織在較低應變速率下更為均勻、細小。通過分析流變應力變化過程中對應的微觀機理，表明高應變速率更利于Mg-5Zn-1Mn鎂合金實現大塑性變形。Mg-5Zn-1Mn合金的變形激活能隨著變形溫度的升高和應變速率的增大而減小。
關鍵字: Mg-5Zn-1Mn合金；流變行為；高應變速率；激活能
（1. College of Materials Science and Engineering, Hunan University, Changsha 410082, China;
2. Hunan Provincial Key Laboratory of Spray Deposition Technology and Application,
Hunan University, Changsha 410082, China;
3. State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China）
Abstract:The hot compression tests were performed on Mg-5Zn-1Mn alloy with the large deformation of 80% by the Gleeble-3500 material simulation machine. The microstructure evolution and flow behaviour were studied at the deformation temperature range from 250 to 400 ℃ and the strain rate range from 1 to 40 s-1. The dynamic recrystallization (DRX) occurs obviously during hot deformation, the DRX microstructure developed at high strain rate is more uniform, and the grain size is smaller than that developed at low strain rate. The severe plastic deformation of ZM51 magnesium alloy can be achieved more effectively at high strain rate compared to low strain rate by analyzing the microscopic mechanism during the change of flow stress. The hot deformation activation energy decreases with increasing the deformation temperature and strain rate.
Key words: Mg-5Zn-1Mn magnesium alloy; flow behaviour; high strain rate; activation energy
