(核工業西南物理研究院，成都 610041)
摘 要: 采用熱等靜壓(HIP)焊接技術制備W/CuCrZr偏濾器部件焊接模塊，分別研究以物理氣相沉積(PVD)制備的40 μm銅涂層作為過渡層，以2 mm厚的TU1銅片作為過渡層以及無過渡層3種結構模塊的焊接界面質量。通過掃描電子顯微鏡(SEM)、超聲波無損探傷儀(NDT)、力學拉伸試驗機和電子束高熱負荷試驗裝置分別對焊接模塊的微觀形貌、焊接缺陷、力學性能和高熱負荷性能進行檢測分析。結果表明：HIP焊接工藝參數為(940 ℃, 120 MPa, 2 h)時，采用40 μm銅涂層為過渡層的模塊焊接界面結合質量最高，且沒有缺陷，經過入射功率密度為20 MW/m2的高熱負荷試驗也沒有失效。因此，該工藝是3種工藝參數下鎢/銅合金偏濾器模塊制造的最佳制備技術。
關鍵字: 鎢銅合金；ITER；偏濾器模塊；熱等靜壓；高熱負荷
（Southwestern Institute of Physics, Chengdu 610041, China）
Abstract:The W/CuCrZr alloy divertor component module was manufactured by hot isostatic pressing (HIP) technique. The interface properties of three modules which have the interlayers with 40 μm thick Cu coating produced by PVD method, 2 mm thick TU1Cu sheet and no interlayer, respectively, were investigated. The microstructure, welding defect, shear strength and high heat load(HHL) test properties were tested by scanning electron microscope (SEM), ultrasonic nondestructive testing (NDT) equipment, mechanical cupping machine and electron beam epuipment(EMS-60), respectively. The results show that the joint performance of module with the interlayer of 40 μm thick Cu coating is the best, the highest bonding strength and free defect are achieved under the HIP condition of (940 ℃, 120 MPa, 2 h). After the screening test with incident power density of 20 MW/m2, the module also has no failure. Therefore, the process can be the optimal technique applied to the manufacturing of divertor component among the three techniques.
Key words: W/CuCrZr alloy; ITER; divertor module; hot isostatic pressing; high heat load
