中國有色金屬學(xué)報(bào)(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 24 No. 7 July 2014 |
（1. Chair of Materials Science, Faculty of Mechanical Engineering and Marine Technology,
University of Rostock, Germany;
2. Polymer-Physics Group, Institute of Physics, University of Rostock, Germany）
Abstract:The precipitation behaviour during quenching of cast Al-7Si-0.3Mg aluminium alloy was investigated by DSC in the cooling rate range of 0.01 K/s to 3 K/s and by quenching dilatometry for higher rates. Two main precipitation reactions were observed during cooling, a high temperature reaction starting almost directly with quenching from 540 °C and a low temperature reaction starting at about 400 °C. Quenching with 3 K/s already significantly suppresses precipitation during quenching. Hardness after T6 ageing increases with increasing quenching rate, due to the increasing content of supersaturated solid solution. By dilatometry and hardness results the critical cooling rate can be estimated as about 60 K/s. Quenched Al-7Si-0.3Mg microstructures have been investigated by light microscopy. The microstructures consist of an aluminium-silicon eutectic structure, aluminium solid solution dendrites and precipitates inside the aluminium dendrites, depending on quenching rate.
Key words: cast aluminium alloy; Al-7Si-0.3Mg; quenching; continuous cooling; precipitation diagram; differential scanning calorimetry; critical cooling rate
