(東北大學 材料電磁過程研究教育部重點實驗室，沈陽 110819)
摘 要: 半固態金屬坯料部分重熔是半固態金屬觸變成形工藝的重要技術環節，為了使坯料獲得既細小又圓整的晶粒組織，對近液相線鑄造ZK60鎂合金半固態坯料進行部分重熔，通過改變重熔溫度和保溫時間來研究其微觀組織的演化規律。結果表明：適當控制加熱溫度和保溫時間，坯料部分重熔時可獲良好的觸變結構。石墨模澆注時，在600~605 ℃、保溫10~15 min時可獲得較理想的觸變結構，平均晶粒尺寸達30.5 μm，圓度達1.5；水冷銅模澆注時，可得出相同的結論，其晶粒平均直徑為31.8 μm，圓度達1.6。且坯料近液相線鑄造時的冷卻速率對部分重熔的進程也產生影響，適當降低鑄造冷卻速率，即采用石墨模能提高二次重熔組織的均勻性和穩定性。
關鍵字: ZK60鎂合金；近液相線鑄造；部分重熔；微觀組織
（Key Laboratory of Electromagnetic Processing of Materials, Ministry of Education,
Northeastern University, Shenyang 110819, China）
Abstract:Partial remelting is the important part of semi-solid metal (SSM) ingots forming technology. In order to obtain small and round grain organization microstructure, the microstructure evolution of ZK60 magnesium alloy SSM ingots obtained by near-liquidus casting were partially remelted, and the microstructure evolution would be investigated by controlling remelting temperature and holding time. The results indicate that good thixotropic microstructure will be obtained by controlling remelting temperature and holding time suitably. Using the graphite mould, optimizing thixotropic microstructure can be obtained at 600-605 ℃ for 10-15 min, the average diameter of grain is 30.5 μm and the roundness is 1.5. With the water-cooled copper mould, the conclusion is the same, the average grain diameter is 31.8 μm and the roundness is 1.6. Meanwhile, the cooling rates during casting also affect the partial remelting progress, reducing the cooling rate properly, the graphite mould can improve the uniformity and stability of the partial remelting microstructure.
Key words: ZK60 magnesium alloy; near-liquidus casting; partial remelting; microstructure
