(西安高新技術研究所 601室，西安 710025)
摘 要: 采用壓縮實驗研究應變速率和變形溫度對新型亞穩β鈦合金Ti2448溫變形行為的影響。熱模擬壓縮實驗在Gleeble-3800熱模擬機上進行，變形溫度為473~673 K，應變速率為0.001~10 s-1，變形程度為45%。結果表明：在高、低應變速率下合金呈現不同的變形特性。低應變速率(0.001~0.1 s-1)下，流動曲線呈現明顯的應變硬化特性；在10 s-1的高應變速率下，流動應力在達到飽和后，因溫升效應而下降；在673 K變形溫度下流動應力因材料內部相變而具有顯著的應變速率負敏感性。基于分段外推飽和模型和改進的Voce 模型分別構建Ti2448合金在溫變形高、低應變速率下的流動應力模型；該模型得到的預測曲線(應力—應變曲線)和實驗曲線吻合較好，能夠有效預測Ti2448合金在溫變形過程中的流動應力，其中，改進的Voce模型能同時較好地描述飽和型和非飽和型應變硬化特性。
關鍵字: 亞穩β鈦合金；溫變形；本構模型
（601 Staff Room, Xi’an High Technology Institute, Xi’an 710025, China）
Abstract:The effects of strain rate and deformation temperature on warm deformation behavior of a new kind of metastable β titanium alloy Ti2448 were investigated by using compression tests. The experiments were carried out on a Gleeble-3800 thermo-mechanical simulator at deformation temperatures of 473-673 K, strain rates of 0.001-10 s-1, and height direction reduction of 45%. The results show that there are different deformation behaviors at high and low strain rates. At low strain rates (0.001-0.1 s-1), there are obvious work hardening behaviors in flow stress curves. At the high strain rate of 10 s-1, the alloy presents obvious hardening firstly, then saturated state and further softening caused by temperature rise finally. At 673 K, the alloy significantly exhibits the stain rate negative sensitivity because of the phase change. Based on the model in which the whole stress—strain curve is divided into the strain hardening part and the saturated state part and the modified Voce model, constitutive models were developed to describe the flow behaviors of Ti2448 alloy at high and low strain rates, respectively. The stress—strain curves predicted by the developed model well fit with the experimental results, which con？rms that the developed model can predict the flow stress of Ti2448 alloy validly and the modified Voce model can describe the strain hardening behavior of both the saturated state and the unsaturated state.
Key words: metastable β titanium alloy; warm deformation; constitutive model
