(1. 中南大學 材料科學與工程學院，長沙 410083；
2. 中南大學 有色金屬材料與工程教育部重點實驗室，長沙 410083；
3. Department of Chemical and Materials Engineering, University of Auckland, Auckland 1102, New Zealand)
摘 要: 采用Gleeble−1500熱模擬機對ZK60鎂合金在溫度為200~400 ℃、應變速率為0.001~10 s−1、最大變形量為60%的條件下進行恒應變速率高溫壓縮實驗，研究高溫變形過程中合金的動態再結晶行為；采用EM模型描述合金的動態回復曲線，以此為基礎，得出ZK60合金熱壓縮過程中的動態再結晶動力學Avrami方程。利用有限元模擬合金熱壓縮過程中的動態再結晶。結果表明：ZK60合金熱壓縮過程中由于存在動態再結晶的軟化作用，流變應力達到峰值后逐漸減小，并最終達到穩態；隨著變形量的增加和變形溫度的升高，動態再結晶體積分數增加，合金變形更加均勻；隨著應變速率的增加，動態再結晶分數有所減小，且變形也更不均勻。
關鍵字: ZK60 鎂合金；熱變形；流變應力；動態再結晶；動力學
ZK60 magnesium alloy during hot deformation
（1. School of Materials Science and Engineering, Central South University, Changsha 410083, China;
2. Key Laboratory of Nonferrous Metal Materials Science and Engineering, Ministry of Education,
Central South University, Changsha 410083, China;
3. Department of Chemical and Materials Engineering, University of Auckland, Auckland 1102, New Zealand）
Abstract:The kinetics of dynamic recrystallization of ZK60 magnesium alloy was investigated by compression tests at temperature of 200−400 ℃ and strain rate of 0.001−10 s−1. The flow stress curves considering only dynamic recovery was described by EM model. Based on EM model, the kinetics of dynamic recrystallization of ZK60 alloy was modeled by an Avrami-type equation. The finite element simulations were utilized to simulate the recrystallization process of ZK60 alloy during hot compression. The results show that, due to the effect of dynamic recovery, the flow stress increases to a peak value and subsequently decreases to steady state. Both the volume fraction of dynamic recrystallization and the deformation homogeneity increase with the increase of the plastic strain and deformation temperature, while decrease with the increase of strain rate.
Key words: ZK60 magnesium alloy; hot deformation; flow stress; dynamic recrystallization; kinetics
