(中南工業大學材料科學與工程系，長沙410083)
摘 要: 通過比較流體潤滑狀態下冷軋變形區摩擦系數與軋機允許最小摩擦系數得出軋制穩定因子KS，用于判斷其軋制過程是否穩定。計算與實驗結果表明：KS值隨壓下率減小而降低，且當KS<1時出現負前滑及摩擦力反向，同時軋后板面質量變差。因此,只有當壓下率達到一定值后，KS>1，才能實現穩定軋制并獲得優異的軋后板面質量。
關鍵字: 冷軋 潤滑 摩擦
（Department of Materials Science and Engineering,Central South University of Technology, Changsha 410083）
Abstract:The stable rolling factor KS was developed to decide the stability of rolling process by comparing the friction coefficient in hydrodynamic lubrication rolling with allowed minimum friction coefficient in rolling. The results in calculations and experiments showed that KS value reduced with decreasing reduction rate, which caused the negative forward slip and a change of friction direction and a poor rolled surface when KS< 1. Only reduction rate reached a certain value and KS>1 can rolling be stable process and good rolled surface quality be obtained.
Key words: cold rolling lubrication friction
