(哈爾濱工業大學應用化學系, 哈爾濱 150001)
摘 要: 研究了在化學鍍Ni-P合金鍍層時， 采用無機鹽復合加速劑降低鍍液溫度、 提高沉積速度的方法。 結果表明， 在普通化學鍍Ni-P合金鍍液中添加無機鹽復合加速劑HN-3(3份(NH4)2SO4與2份K2CO3的混合物)30g/L， 在80℃下施鍍， 其沉積速度可達15μm/h， 比不含該加速劑時提高40%左右， 鍍液壽命可達5個周期以上， 鍍層外觀光亮，結晶細致。
關鍵字: 化學鍍 Ni-P合金 加速劑
ELECTROLESS Ni-P ALLOY
（Department of Applied Chemistry,ª¤Harbin Institute of Technology, Harbin 150001, P. R. China
）
Abstract:In the processing of electroless Ni-P alloy coating, inorganic composite accelerant was used to reduce operational temperature and not to reduce deposition rate. By comparing experimental results, it was shown that the inorganic composite HN-3((NH4)2SO4/K2CO3=3/2) is an appropriate accelerant. Adding the HN-3 accelerant 30 g/L into the ordinary bath of electroless Ni-P alloy at 80¡æ, the deposition rate can reach 15¦Ìm/h that is 40% higher than that in the absence of HN-3 accelerant. The life of the bath can maintain over 5 cycles. The coated films have bright appearance and compactive grain.
Key words: electroless plating Ni-P alloy inorganic composite accelerant
