(東北大學材料與冶金學院，沈陽 110006
墨爾本大學機械制造工程系，澳大利亞)
摘 要: 采用常規鑄造和液相線鑄造的2618鋁合金在Gleeble-1500型熱學-力學模擬試驗機上在不同變形溫度和變形速率下進行半固態壓縮，變形溫度為490～600℃，變形速率為5×10-3～5×10-1s-1。結果表明，常規鑄造組織、液相線鑄造組織半固態壓縮變形抗力均小于固態壓縮變形抗力，并且液相線鑄造獲得的細小、等軸、非枝晶組織在半固態壓縮時的變形抗力小于常規鑄造枝晶組織的變形抗力。液相線鑄造組織的成形性能優于常規鑄造組織。
關鍵字: 鋁合金 常規鑄造 液相線鑄造 半固態 壓縮變形
（Materials and Metallurgy College, Northeastern University, Shenyang 110006, P. R. China
Department of Mechanical and Manufacturing Engineering, Melbourn University, Australia）
Abstract:2618 aluminum alloy attained by conventional casting and liquidus casting was compressed in semi-solid at different deformation temperatures from 490 ～600℃ and different deformation rates ranging from 5×10-3 to 5 ×10-1s-1 by means of Gleeble-1500 thermal-mechanical simulator. The results showed that the resistance to deformation of compression in semi-solid state is lower than that in solid state, for both conventional casting and liquidus casting structures; the resistance to deformation of the fine, equiaxed and non-dendritic grains of primary microstructure attained by liquidus casting in semi-solid state is remarkably lower than that of conventional casting dendritic microstructure; the formability of liquidus cast structure is better than that of the conventional cast structure.
Key words: 2618 aluminum alloy; conventional casting; liquidus casting; semi-solid; compression deformation
