(1. 北京航空工藝研究所，北京 100024；
2. 天津大港油田管理局，天津 300000)
摘 要: 分析了鈦與不銹鋼相變擴散連接的工藝參數，利用萬能拉伸試驗機測試了接頭拉伸強度，利用掃描電鏡(SEM)及X射線衍射(XRD)分析了接頭斷口形貌及組成相。結果表明：當連接壓力為13MPa、上限溫度為1183～1203K、下限溫度為1073～1093K、加熱速度為30～50K/s、冷卻速度為15～20K/s、循環次數為15～20次時，鈦與不銹鋼相變擴散連接接頭界面無反應相生成，拉伸強度為380MPa以上，實現了鈦與不銹鋼的高效高強度連接。
關鍵字: 相變擴散連接；鈦；不銹鋼
phase transformation diffusion bonding on
joint strength of Ti/stainless steel
（1. Beijing Aeronautical Manufacturing Technology Research Institute,
Beijing 100024, China;
2. Tianjin Dagang Oil Field Administrative Office, Tianjing 300000, China）
Abstract:The technological parameters of the phase transformation diffusion bonding (PTDB) of the titanium and stainless steel were studied. The tensile strength was tested by using the omnipotence testing machine and the fracture characteristics and phase were analyzed by scanning electron micros copy and X-ray diffraction. The results show that: at the maximum cyclic temperature of 1173～1223K, the minimum cyclic temperature of 1073～1093K, the heating velocity of 30～50K/s, the cooling velocity of 15～20K/s, the cycle numbers 15～20 and the bonding pressure of 13MPa, there is not reactive phase on the interface of the phase transformation diffusion bonding(PTDB) joint of the titanium and stainless steel, the tensile strength of joints is higher than 380MPa, thus the high efficiency and high strength bonding of the titanium and stainless steel are realized.
Key words: phases transformation diffusion bonding; titanium; stainless steel
