(中南大學 材料科學與工程系， 長沙 410083)
摘 要: 采用取向分布函數(ODF)研究了軋制幾何因素、軋制摩擦條件對高純鋁箔軋制織構的影響。結果顯示，如果軋制摩擦因數大，當處于均勻變形幾何條件1<ld/d<5時，仍會出現粘著剪切變形，導致產生剪切織構CubeND；如果潤滑條件良好，即使ld/d達到7～10，處于不均勻變形軋制幾何條件時，也未發現剪切織構CubeND。因此，考慮剪切織構CubeND產生時，要注意到在幾何因素與摩擦條件的耦合作用中，摩擦條件對CubeND織構的產生具有更加明顯的影響。
關鍵字: 軋制幾何因子；摩擦；織構；高純鋁箔
friction on shear texture in high
purity aluminum foils
ZHOU Zhuo-ping
（Department of Materials Science and Engineering,
Central South University, Changsha 410083, China）
Abstract:Coupling effect of rolling geometry and friction on shear texture in high purity aluminum foils was investigated by orientation distribution function (ODF). The results show that the shear texture ND-rotated cube texture (CubeND) is observed even if the homogeneous deformation condition, 1<ld/d<5, is met, which may be attributed to the heavy shear strain in deformation zone due to high friction conditions. In spite of the large ratio of ld/d, 7～10, at which there should occur heavy shear strain, the CubeND is not observed because of low friction conditions. In regard to the CubeND of high purity aluminum foils, the rolling geometry should be considered together with friction; the effect of friction on the formation of CubeND may outweigh that of rolling geometry in their coupling.
Key words: rolling geometry; friction; shear texture; high purity Al foils
