(1. 中南大學 粉末冶金國家重點實驗室， 長沙 410083;
2. 廣島大學 工學部機械系， 廣島1-4-1 739-8527)
摘 要: 對壓痕法和單邊切口梁法所測MoSi2基復合材料的斷裂韌性作了研究和分析，提出了壓痕法測量MoSi2基復合材料斷裂韌性的計算修正式。結果表明：單邊切口梁法的測量結果隨試樣切口寬度的增加而增大，壓痕法測量的結果隨計算式和試驗載荷的不同而異。使用上述修正式將縮小壓痕法與SENB法的測量偏差。
關鍵字: 斷裂韌性； 壓痕法； 單邊切口梁法； MoSi2
of molybdenum disilicide matrix composites
（1. State Key Laboratory for Powder Metallurgy,
Central South University, Changsha 410083, P.R.China；
2. Department of Mechanical Engineering, Hiroshima University,
Kagamiyama 1-4-1, 739-8527, Japan）
Abstract: Vikers microhardness indentation and single edge-notched beam specimen techniques were evaluated, and the modified equation was presented in the measurement of fracture toughness of molybdenum disilicide matrix composites. The fracture toughness value of tested material increased with the increasing of notch breadth in single edge-notched beam technique, the results of Vikers indentation method had notable difference with using different equations and different applied loads. It was suggested that the above modified equation might be used to improve the accuracy of the evaluation value.
Key words: fracture toughness; indentation technique; single edgenotched beam specimen technique; molybdenum disilicide
