變形行為
(1. 湘潭大學 材料與光電物理學院，湘潭 411105；
2. 湘潭大學 材料設計與制備技術湖南省重點實驗室，湘潭 411105；
3. 湘潭大學 能源工程學院，湘潭 411100；
4. 湘潭大學 土木工程與力學學院，湘潭 411105)
摘 要: 利用納米壓痕技術研究直徑為3 mm的{[(Fe0.6Co0.4)0.75B0.2Si0.05]0.96Nb0.04}96Cr4塊體非晶合金的變形行為以及加載速率對其塑性變形行為的影響規律。結果表明：該塊體非晶合金在低加載速率下表現出顯著的鋸齒流變，而在高的加載速率下表現為連續的塑性變形；在納米壓痕過程中，該塊體非晶合金出現室溫蠕變現象，且其硬度值隨著加載速率的增大而減小。
關鍵字: 塊體非晶合金；納米壓痕；鋸齒流變；蠕變
（1. Faculty of Materials Optoelectronics and Physics, Xiangtan University, Xiangtan 411105, China;
2. Key Laboratory of Materials Design and Preparation Technology of Hunan Province,
Xiangtan University, Xiangtan 411105, China;
3. College of Energy Engineering, Xiangtan University, Xiangtan 411100, China;
4. College of Civil Engineering and Mechanics, Xiangtan University, Xiangtan 411105, China）
Abstract:The deformation behaviour of {[(Fe0.6Co0.4)0.75B0.2Si0.05]0.96Nb0.04}96Cr4 bulk amorphous alloy with a diameter of 3 mm and the influence of loading rate on its plastic deformation were investigated by the technique of nanoindentation. The results show that the {[(Fe0.6Co0.4)0.75B0.2Si0.05]0.96Nb0.04}96Cr4 bulk amorphous alloy exhibits prominent serrated flow at low loading rate while the plastic deformation is continuous at high loading rate. During nanoindentation, the room temperature creep of the {[(Fe0.6Co0.4)0.75B0.2Si0.05]0.96Nb0.04}96Cr4 bulk amorphous alloy is observed, and its hardness decreases with the increase of loading rate.
Key words: bulk amorphous alloy; nanoindentation; serrated flow; creep
