( 1. 山東建筑工程學院 材料科學與工程系， 濟南 250014;
2. 山東大學 材料液態結構及其遺傳性國家教育部重點實驗室，
濟南 250061)
摘 要: 利用Al2（SO4）3分解， 在鋁熔體中原位生成Al2O3顆粒。實驗結果表明： 采用石墨坩堝、 電磁攪拌和鋁熔體中加入鎂的工藝流程， 可實現Al2O3顆粒和鋁熔體的有效復合，進而制備出Al2O3（p）/ZA35鋅基復合材料； 與基體合金ZA35相比， 復合材料的耐磨減摩性能有了明顯的提高。
關鍵字: 復合材料; 鋅合金; 電磁攪拌
Al2O3（p）/ZA35 composite with in-situ process
（ 1. Department of Materials Science and Engineering,
Shandong Institute of Architecture and Engineering,
Ji′nan 250014, China;
2. The Key Laboratory of Liquid Structure and Heredity of Materials,Ministry of Education, Shandong University,
Ji′nan 250061, China）
Abstract: By means of decomposition of Al2（SO4）3, Al2O3 particles were formed in situ in Al melt. The results show that by using graphite crucible and the method of electromagnetic stirring and adding Mg into Al melt, the combination between Al2O3 particles and Al melt is performed effectively. Basing that, Al2O3（p）/ZA35 zinc based composites was fabricated. The friction coefficient and wear resistance of Al2O3(p) /AZ35 zinc based composites were proved to be superior to those of matrix alloy ZA35 obviously.
Key words: composite; zinc alloy; electromagnetic stirring
