抗拉強度的影響
(華南理工大學 機械工程學院， 廣州 510640)
摘 要: 采用溫壓方法制備了高密度Fe-2Ni-2Cu-1Mo-1C材料， 并研究了燒結溫度和燒結時間對溫壓Fe-2Ni-2Cu-1Mo-1C材料燒結密度和抗拉強度的影響。結果表明： 常規溫壓和模壁潤滑溫壓的燒結密度和抗拉強度隨燒結溫度和時間的變化而變化， 模壁潤滑溫壓的燒結密度和抗拉強度均大于常規溫壓的； 溫壓材料的抗拉強度為燒結溫度和燒結時間的函數，常規溫壓和模壁潤滑溫壓的抗拉強度隨燒結溫度和時間變化的線性回歸方程（R為相關系數）分別為σb=575＋211 153 6f(t, T)， R=0.972和σb=595＋208 688 3f(t, T)， R=0.997。
關鍵字: Fe-2Ni-2Cu-1Mo-1C; 溫壓鐵基材料； 抗拉強度； 燒結； 回歸方程
tensile strength of warm compacted
Fe-2Ni-2Cu-1Mo-1C material
WEN Li-ping, LI Yuan-yuan
（College of Mechanical Engineering,
South China University of Technology, Guangzhou 510640, China）
Abstract: The high density Fe-2Ni-2Cu-1Mo-1C material was fabricated by warm compaction method, and the influence of sintering temperature and sintering time on the density and tensile strength of warm compacted Fe-2Ni-2Cu-1Mo-1C sintered material were studied. The results show that the sintered density and tensile strength of the conventional warm compacted and die wall lubricating warm compacted samples change with the change of sintering temperatures and time. The sintered density and tensile strength of the die wall lubricating warm compacted material are larger than those of conventional warm compacted samples. The tensile strengths of warm compacted ferrous materials are functions of sintering temperatures and time. The regression for conventional warm compaction conditions and die wall lubricating warm compaction conditions are that σb=575＋211 153 6 f(t, T), R=0.972 and σb=595＋208 688 3 f(t, T)， R=0.997, respectively.
Key words: Fe-2Ni-2Cu-1Mo-1C; warm compacted ferrous material; tensile strength; sintering; regression function
