(西安理工大學 材料科學與工程學院，西安 710048)
摘 要:
采用濕法表面包覆將5種單一表面改性劑按不同的比例包覆于銅鋅粉末的表面，測試包覆后銅鋅粉末的潤濕性、漂浮性以及印刷光澤度，并且分析了改性劑對銅鋅粉末潤濕性和漂浮性的影響機理。結果表明，經 1%月桂酸鈉包覆的銅鋅粉末的潤濕性降低最多，經2%吐溫-80包覆的銅鋅粉末的漂浮性升高最多，2%吐溫-80對銅鋅粉末潤濕性的降低和漂浮性的升高都有較大的改善，包覆后的銅鋅粉末印刷光澤度由原來的54.4提高到75.5，基本可以滿足印刷對銅鋅粉末的要求。
關鍵字: 銅鋅粉末；表面活性劑；漂浮性；潤濕性
（School of Materials Science and Engineering, Xi’an University of Technology, Xi’an 710048, China）
Abstract:Five kinds of single surfactant were coated on the surface of bronze powder by wet method in different proportions, the wettability, floating property and gloss of the coated bronze powders were measured, and the influence mechanisms of the surfactants on the wettability and floating property of the bronze powders were analyzed as well. The results show that the wettability of the bronze powders coated by 1% sodium laurate has the largest decrease and the floating property of the bronze powders coated by 2% tween-80 has the largest increase. 2% tween-80 has significant improvement on the decrease of the wettability and the increase of the floating property of bronze powders. The gloss of the coated bronze powders increases from 54.5 to 75.5, thus can meet the printing requirements for bronze powders.
Key words: bronze powder; surfactant; floating property; wettability
