Cu-1Mg-1V合金的組織及性能
(1. 沈陽工業大學 材料科學與工程學院，沈陽110023；
2. 遼寧工程技術大學 材料科學與工程系，阜新 123000)
摘 要: 采用噴射沉積快速凝固技術制備了Al-17Si-5Fe-2Mn-2Ni-3.5Cu-1Mg-1V合金，利用金相、X射線衍射和SEM等測試方法分析了合金的組織特征、熱穩定性及力學性能。結果表明：噴射沉積合金的組織由大量彌散分布的粒狀相、少量塊狀相和共晶基體組成。擠壓態合金經300 ℃不同時間加熱后，初晶Si相沒有明顯的粗化，熱穩定性良好；合金經熱擠壓后，室溫極限拉強度達232.2 MPa，經T6熱處理后極限抗拉強度提高了17%，達271.3 MPa。
關鍵字: Al-Si合金；顯微組織；噴射沉積；熱穩定性；力學性能
Al-17Si-5Fe-2Mn-2Ni-3.5Cu-1Mg-1V alloy
（1. School of Materials Science and Engineering, Shenyang University of Technology, Shenyang 110023, China;
2. Department of Materials Science and Engineering, Liaoning Technical University, Fuxin 123000, China）
Abstract:Al-17Si-5Fe-2Mn-2Ni-3.5Cu-1Mg-1V alloy was prepared by spray-deposition technology, a kind of rapid solidification. The microstructure, thermal stability and mechanical properties were investigated by optical microscopy, XRD and SEM. The results show that the microstructures of alloy are composed of lots of dispersed granular phases, block like phases and eutectic matrixes. The hypereutectic Si phase is coarsened evidently and the thermal stability of the alloy is good when the extruding alloys are heattreated at 300 ℃ for different time. The ultimate tensile strength of the as-extruded alloy is 232.2 MPa at room temperature, and the value reaches 271.3 MPa after T6 process, which is increased about 17% than that of the former.
Key words: Al-Si alloy; microstructure; spray-deposition; thermal stability; mechanical properties
