中國有色金屬學(xué)報(bào)(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 34 No. 3 March 2024 |
（1. Key Laboratory for Light-weight Materials, Nanjing Tech University, Nanjing 211816, China;
2. College of Materials Science and Engineering, Chongqing University, Chongqing 400044, China;
3. School of Materials Science and Engineering, Jiangsu University, Zhenjiang 212013, China;
4. National Engineering Research Center of Near-net-shape Forming for Metallic Materials, South China University of Technology, Guangzhou 510640, China;
5. School of Materials Science and Engineering, Nanjing Institute of Technology, Nanjing 211167, China）
Abstract:The effects of Cu content and heat treatment process on the microstructures and mechanical properties of a series of Al-Si-Mg-Mn-xCu cast aluminum alloys prepared by the vacuum die casting process were investigated by three-dimensional X-ray microscopy, optical microscopy, scanning electron microscopy, transmission electron microscopy and microhardness testing. It was found that the number density and size of gas porosities increase with increasing Cu content. However, the Cu addition will promote the formation of Cu-containing primary phases (Q-Al5Cu2Mg8Si6 and θ-Al2Cu) during the solidification, which will improve the properties of the alloys. Five different primary phases were observed, namely eutectic Si, α-Al(Fe,Mn)Si, β-Mg2Si, Q-Al5Cu2Mg8Si6, and θ-Al2Cu phases. With increasing the Cu content, the θ phase area fraction increases significantly, while the α-Al(Fe,Mn)Si phase area fraction decreases initially, followed by a slight increase, with the Q phase area fraction displaying the opposite trend relative to α-Al(Fe,Mn)Si phase. These primary phases present different evolution rules during heat treatment process. During subsequent aging, the synergic effect of precipitating Q？ and θ？ phases can significantly increase the alloy hardening response.
Key words: Al-Si cast alloy; vacuum die casting; heat treatment; microstructure; mechanical properties; primary phases
